The forward recognition camera receives a lane departure alert main switch signal from the steering pad switch assembly.
The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Remove the steering pad switch assembly.
Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>REMOVAL
Inspect the steering pad switch assembly.
Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>REMOVAL
Inspect the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K22 spiral cable sub-assembly connector.
Disconnect the V6 forward recognition camera connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K22-6 (DIST) - V6-3 (LKSW) | Always | Below 1 Ω |
| K22-6 (DIST) or V6-3 (LKSW) - Body ground | Always | 10 kΩ or higher |
Connect the V6 forward recognition camera connector.
Connect the K22 spiral cable sub-assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for A25A-FKS:
Disconnect the K22 spiral cable sub-assembly connector.
Disconnect the A24 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K22-2 (ECC) - A24-28 (ECCS) | Always | Below 1 Ω |
| K22-2 (ECC) or A24-28 (ECCS) - Body ground | Always | 10 kΩ or higher |
Connect the A24 ECM connector.
Connect the K22 spiral cable sub-assembly connector.
for 2AR-FE:
Disconnect the K22 spiral cable sub-assembly connector.
Disconnect the A22 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K22-2 (ECC) - A22-35 (ECCS) | Always | Below 1 Ω |
| K22-2 (ECC) or A22-35 (ECCS) - Body ground | Always | 10 kΩ or higher |
Connect the A22 ECM connector.
Connect the K22 spiral cable sub-assembly connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG