The main body ECU (multiplex network body ECU) receives switch signals from the luggage compartment door opening switch assembly and operates the luggage compartment door lock assembly to open the luggage compartment door.
The luggage compartment door opener system uses the CAN communication system. First, confirm that there is no malfunction in the CAN communication system. Refer to the How to Proceed with Troubleshooting procedure.
Before replacing the main body ECU (multiplex network body ECU) or certification ECU (smart key ECU assembly)*, refer to Service Bulletin.
*: w/ Smart Entry and Start System
The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing this troubleshooting procedure, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
*: w/ Door Control Battery
Check power door lock control system operation.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
Power door lock control system is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check wireless door lock control system operation.
w/ Smart Entry and Start System: Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM (w/ Smart Entry and Start System)>OPERATION CHECK
w/o Smart Entry and Start System: Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM (w/o Smart Entry and Start System)>OPERATION CHECK
Wireless door lock control system is normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ Smart Entry and Start System) | B |
| NG (w/o Smart Entry and Start System) | C |
A
B
C
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Trunk and Back-Door Open | Operate luggage compartment door lock assembly latch release | OFF or ON | - |
| Tester Display |
|---|
| Trunk and Back-Door Open |
Luggage compartment door lock assembly latch release motor operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Trunk/BDoor Open SW | Luggage compartment door opening switch signal | OFF or ON | OFF: Luggage compartment door opening switch off
ON: Luggage compartment door opening switch on |
- |
| Luggage Courtesy SW | Luggage compartment door courtesy light switch signal | OFF or ON | OFF: Luggage compartment door courtesy light switch off
ON: Luggage compartment door courtesy light switch on |
- |
| Tester Display |
|---|
| Trunk/BDoor Open SW |
| Luggage Courtesy SW |
The GTS display changes correctly in response to the ON/OFF operation of the luggage compartment door opening switch or luggage compartment door courtesy light switch.
| Result | Proceed to |
|---|---|
| OK (w/o Smart Entry and Start System) | A |
| OK (w/ Smart Entry and Start System) | B |
| NG (Trunk/BDoor Open SW) | C |
| NG (Luggage Courtesy SW) | D |
A
B
C
D
Enter the following menus: Body Electrical / Entry&Start / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Tr/B-Door Unlock SW | Luggage electrical key switch | OFF or ON | OFF: Luggage electrical key switch not pressed
ON: Luggage electrical key switch pressed |
When this item is abnormal, there is a malfunction in the luggage electrical key switch or related parts. |
The GTS display changes correctly in response to the operation of the luggage electrical key switch.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the luggage compartment door opening switch assembly.
Click hereVehicle Exterior>DOOR / HATCH>LUGGAGE COMPARTMENT DOOR OPENER INNER SWITCH>REMOVAL
Inspect the luggage compartment door opening switch assembly.
Click hereVehicle Exterior>DOOR / HATCH>LUGGAGE COMPARTMENT DOOR OPENER INNER SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K53 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K53-4 (TSW) - K42-5 | Always | Below 1 Ω |
| K42-2 - Body ground | Always | Below 1 Ω |
| K53-4 (TSW) or K42-5 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the luggage compartment door lock assembly.
Click hereVehicle Interior>DOOR LOCK>LUGGAGE COMPARTMENT DOOR LOCK>REMOVAL
Inspect the luggage compartment door lock assembly.
Click hereVehicle Interior>DOOR LOCK>LUGGAGE COMPARTMENT DOOR LOCK>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W3-3 (D+) - 3D-34 | Always | Below 1 Ω |
| W3-1 (B) - 3D-20 | Always | Below 1 Ω |
| W3-2 (E) - Body ground | Always | Below 1 Ω |
| W3-3 (D+) or 3D-34 - Body ground | Always | 10 kΩ or higher |
| W3-1 (B) or 3D-20 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the instrument panel junction block assembly with a new or known good one.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Check that the luggage door opener system is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG