The main body ECU (multiplex network body ECU) controls the rear fog light.
Inspect the fuses for circuits related to this system before performing the following procedure.
The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing this troubleshooting procedure, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*1
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*2
*1: w/ Door Control Battery
*2: w/ Smart Entry and Start System
Check the operation of the taillights.
Taillights operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Rear Fog Light Relay | Rear fog lights | OFF or ON | Light control switch in tail position |
| Tester Display |
|---|
| Rear Fog Light Relay |
Rear fog light relay operates. (Rear fog lights come on.)
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the W15 rear light assembly LH connector.
Disconnect the 3D instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| W15-3 (B) - 3D-21 | Always | Below 1 Ω |
| W15-3 (B) or 3D-21 - Body ground | Always | 10 kΩ or higher |
| W15-4 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Connect a positive (+) lead from the battery to terminal 3F-1.
Connect a negative (-) lead from the battery to terminal MB-14 (TRLY) and MB-27 (RFGO).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3D-21 - Battery negative (-) terminal | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG