Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for 2AR-FE) › 2017.09–2017.12
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0327281 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE)  C1A52  Radar Cruise Control Presence Determination Malfunction (Engine / HV)  


DESCRIPTION

DTC C1A52 is stored when the ECM cannot recognize the millimeter wave radar sensor assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A52 Radar Cruise Control Presence Determination Malfunction (Engine / HV) Approximately 17 seconds after the engine switch is on (IG), the ECM cannot recognize the millimeter wave radar sensor assembly for approximately 1.3 seconds or more.
·

ECM

·

Millimeter wave radar sensor assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.

·

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT

·

Before replacing the ECM, refer to Service Bulletin.



PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 197

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the engine switch on (IG).

2.

Wait for 20 seconds or more.




c.

Check for DTCs.

Powertrain > Radar Cruise2 > Trouble Codes
50001 197

Result:
Result Proceed to
DTC C1A52 is not output A
DTC C1A52 is output B



A

B

2.REPLACE ECM
2.REPLACE ECM

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 197

b.

Perform the following procedure.

HINT:

If the following procedure is not performed, the previously output DTC cannot be detected.

1.

Turn the engine switch on (IG).

2.

Wait for 20 seconds or more.




c.

Check for DTCs.

Powertrain > Radar Cruise2 > Trouble Codes
50001 197

Result:
Result Proceed to
DTC C1A52 is not output A
DTC C1A52 is output B



A

END (ECM WAS DEFECTIVE)

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY