Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › from 2017.12
RM33A0E _51 Engine / Hybrid System _065332 2GR-FKS ENGINE CONTROL _0326385 CRANKSHAFT POSITION SENSOR A

2GR-FKS ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 17150 1.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst)

Hide 19312 2.REMOVE CRANKSHAFT POSITION SENSOR PROTECTOR

a.
A408199

w/ Oil Cooler:

i.

Remove the nut and hose clamp from the crankshaft position sensor protector.



b.
A408203

Remove the 3 bolts and crankshaft position sensor protector from the cylinder block sub-assembly and oil pan sub-assembly.


Hide 11401G 3.REMOVE CRANKSHAFT POSITION SENSOR

a.
A408201

Disconnect the crankshaft position sensor connector.


b.

Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

NOTICE:

If the crankshaft position sensor has been struck or dropped, replace it.