Home › Brake › BRAKE (FRONT) › FRONT BRAKE(for 17 inch Front Disc Brake) › from 2017.12
RM33A0E _54 Brake _065367 BRAKE (FRONT) _0341733 FRONT BRAKE(for 17 inch Front Disc Brake) A

BRAKE (FRONT)  FRONT BRAKE(for 17 inch Front Disc Brake)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Immediately after installing the front disc brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.

·

After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.



HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.DRAIN BRAKE FLUID

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.


Hide 47313J 3.DISCONNECT FRONT FLEXIBLE HOSE

a.
C380692

Remove the union bolt and gasket, and disconnect the front flexible hose from the front disc brake cylinder assembly.


Hide 47750 4.REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY

a.
C380693C01
1.438,1.469 1.698,1.667 0.26,0.198 10 true *a 2.156,1.448 2.375,1.625 0.219,0.177 10 true *b
*a Turn
*b Hold


Hold the 2 front disc brake cylinder slide pins and remove the 2 bolts and front disc brake cylinder assembly.


Hide 5.REMOVE FRONT DISC BRAKE PAD

a.
C380694

Remove the 2 anti-squeal springs.


b.
C380695

Remove the 2 front disc brake pads from the front disc brake cylinder mounting.


Hide 04945 6.REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT

Hide 7.REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE

a.
C380696

Remove the 4 front disc brake pad support plates from the front disc brake cylinder mounting.

NOTICE:

Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that it can be reinstalled to its original position.



Hide 47715A 8.REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN

a.
C380697

Remove the 2 front disc brake cylinder slide pins from the front disc brake cylinder mounting.


b.
C336928C05
2.083,1.385 2.438,0.813 2.438,0.813 2.531,0.813 false 2.583,0.75 2.896,0.906 0.313,0.156 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, remove the front disc brake cylinder slide bushing from the front disc brake cylinder slide pin (lower side).

NOTICE:

Do not damage the front disc brake cylinder slide pin.



Hide 9.REMOVE FRONT DISC BRAKE BUSHING DUST BOOT

a.
C380698

Remove the 2 front disc brake bushing dust boots from the front disc brake cylinder mounting.


Hide 47722 10.REMOVE FRONT DISC BRAKE CYLINDER MOUNTING

a.
C380699

Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.


Hide 43512 11.REMOVE FRONT DISC

a.
C380700C01
1.833,1.01 2.781,1.01 true 1.854,1.083 2.583,1.083 2.583,1.083 2.583,1.01 true 2.823,0.927 2.99,1.083 0.167,0.156 10 true *a
*a Matchmark


Put matchmarks on the front disc and the front axle hub sub-assembly.


b.

Remove the front disc.