The main body ECU (multiplex network body ECU) controls the operation of the TAIL relay.
for LHD
for RHD
Inspect the fuses for circuits related to this system before performing the following procedure.
The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing this troubleshooting procedure, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*1
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*2
*1: w/ Door Control Battery
*2: w/ Smart Entry and Start System
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Taillight Relay | Taillight relay | OFF or ON | - |
| Tester Display |
|---|
| Taillight Relay |
Taillights illuminate.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 3F*1 or 3G*2 instrument panel junction block assembly connector.
*1: for LHD
*2: for RHD
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3F-1 - Body ground | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3G-1 - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *A | for LHD | *B | for RHD |
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL
Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Connect a positive (+) lead from the battery to terminal 3F-1*1 or 3G-1*2.
*1: for LHD
*2: for RHD
Connect a negative (-) lead from the battery to terminal MB-14 (TRLY).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3C-32 - Battery negative (-) terminal* | Always | 11 to 14 V |
| 3D-30 - Battery negative (-) terminal | Always | 11 to 14 V |
*: w/ Front Fog Light
| Proceed to |
|---|
| OK |
| NG |
OK
NG