The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
53295E
1.REMOVE COOL AIR INTAKE DUCT SEAL
17750A
2.REMOVE INLET AIR CLEANER ASSEMBLY
22030
3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
25620
4.REMOVE EGR VALVE ASSEMBLY
89421
5.REMOVE E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
82121
6.DISCONNECT ENGINE WIRE
Remove the bolt.
Disengage the wire harness clamp and disconnect the engine wire.
16278
7.REMOVE NO. 2 WATER BY-PASS PIPE
Using an 8 mm socket wrench, remove the 2 bolts (A) and separate the No. 2 water by-pass pipe from the intake manifold.
Remove the bolt (B) and No. 2 water by-pass pipe from the cylinder block sub-assembly.
16279
8.DISCONNECT NO. 3 WATER BY-PASS PIPE
Slide the clip and disconnect the No. 5 water by-pass hose from the No. 3 water by-pass pipe.
Using an 8 mm socket wrench, remove the bolt and disconnect the No. 3 water by-pass pipe from the intake manifold.
23820
9.DISCONNECT NO. 2 FUEL VAPOR FEED HOSE
Disconnect the No. 2 fuel vapor feed hose from the intake manifold.
17111
10.REMOVE INTAKE MANIFOLD
w/o Stud Bolt:
Remove the 5 bolts and intake manifold from the cylinder head sub-assembly.
w/ Stud Bolt:
Remove the 3 bolts and 2 nuts.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and intake manifold from the cylinder head sub-assembly.
17177
11.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET
Remove the No. 1 intake manifold to head gasket from the intake manifold.
12611B
12.REMOVE NO. 1 ENGINE COVER
Remove the clip and No. 1 engine cover.
13.REMOVE VACUUM HOSE
Remove the vacuum hose from the intake manifold.