Use the same procedure for the RHD side and LHD side.
The following procedure is for the LHD side.
55435B
1.REMOVE NO. 1 METER HOOD CLUSTER (w/o Driver Side Knee Airbag)
55434B
2.REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL (w/o Driver Side Knee Airbag)
67914
3.REMOVE FRONT DOOR SCUFF PLATE LH
62112A
4.REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
62312B
5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
55318C
6.REMOVE INSTRUMENT SIDE PANEL LH
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)
55606
8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
55436B
9.REMOVE NO. 2 METER HOOD CLUSTER
53601
10.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55302D
11.REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)
55302D
12.REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (w/ Driver Side Knee Airbag)
84153
13.REMOVE AUTO HIGH BEAM SWITCH
for LHD:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the auto high beam switch as shown in the illustration.
for RHD:
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the auto high beam switch as shown in the illustration.