Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM (w/ Automatic Headlight Beam Level Control System) › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0329531 LIGHTING SYSTEM(w/ Automatic Headlight Beam Level Control System) C

LIGHTING (EXT)  LIGHTING SYSTEM(w/ Automatic Headlight Beam Level Control System)  B2456  Left Headlight ECU Variation Error  


DESCRIPTION

This DTC is stored if the headlight ECU sub-assembly LH for another destination is installed.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
B2456 Left Headlight ECU Variation Error
Detection condition:

The ignition switch is ON.


Malfunction status:

Vehicle specification information received via CAN communication is continuously mismatched


Malfunction duration:

-


·

ECM

·

Main body ECU (multiplex network body ECU)

·

Headlight ECU sub-assembly LH


Headlight ECU sub-assembly LH

CAUTION / NOTICE / HINT

NOTICE:
·

If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Automatic Headlight Beam Level Control System)>INITIALIZATION

·

The vehicle battery supplies power to the main body ECU (multiplex network body ECU) via the door control battery. Therefore, before performing this troubleshooting procedure, make sure to perform an on-vehicle inspection to confirm that the main body ECU (multiplex network body ECU) power source circuit is normal.*1

Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>ON-VEHICLE INSPECTION

·

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.*2

·

Before replacing the ECM, refer to Service Bulletin.*2

*1: w/ Door Control Battery

*2: w/ Smart Entry and Start System




PROCEDURE

1.CLEAR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.


e.

Clear the DTCs.

Body Electrical > HL AutoLeveling > Clear DTCs
50002 361

Result:
Proceed to
NEXT



NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.


e.

Check for DTCs.

Body Electrical > HL AutoLeveling > Trouble Codes
50001 361
OK:

DTC B2456 is not output.



Result:
Proceed to
OK
NG



OK

NG

3.CHECK ECM
3.CHECK ECM
a.

Check if the part number of the ECM installed to the vehicle is correct.

OK:

Part number is correct.



Result:
Proceed to
OK
NG



OK

4.CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

4.CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct.

OK:

Part number is correct.



Result:
Proceed to
OK
NG



OK

REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH

NG

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)