Home › Drivetrain › U761E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM › 2018.04–2021.02
RM33A0E _52 Drivetrain _072210 U761E AUTOMATIC TRANSMISSION / TRANSAXLE _0351183 AUTOMATIC TRANSAXLE SYSTEM D

U761E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  ROAD TEST  


PROBLEM SYMPTOM CONFIRMATION


a.

Based on the result of the customer problem analysis, try to reproduce the symptoms. If the problem is that the transaxle does not shift up, shift down, or the shift point is too high or too low, conduct the following road test referring to the automatic shift schedule and simulate the problem symptoms.



ROAD TEST


CAUTION:
·
A371909

Strictly obey all traffic rules and regulations.

·

Do not drive the vehicle with the GTS cable contacting the pedals, shift lever or steering wheel.

·

Driving the wheel with the GTS cable contacting these areas could impede vehicle control, resulting in a serious accident.


·
A356953

Do not operate the GTS while driving the vehicle.

·

Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.



NOTICE:
·

Be sure to inspect and adjust the engine before performing these tests.

·

Perform the road test with the engine coolant temperature between 60 and 100°C (140 and 212°F) and the ATF temperature between 50 and 100°C (122 and 212°F).

·

Perform these tests with the air conditioning and cruise control off.

Inspection Procedure
Transmission Control Switch Test With the vehicle stationary and the shift lever in D, move the shift lever to S and return it to D. Check that the meter display changes from D to the appropriate S range and then back again.
S Position Test With the vehicle stationary and the shift lever in S, move the shift lever to "+" and "-". Check that the meter display changes between S ranges properly.
D Position Shift Test While driving the vehicle normally, check that the transaxle shifts up and down through each gear properly.
Lock-up Function While driving on a level surface at a constant speed in the lock-up range with the shift lever in D, lightly depress the accelerator pedal and check that the engine speed does not change abruptly.
P Position Test Stop the vehicle on an incline (approximately 5° or more). Move the shift lever to P and release the parking brake. Check that the parking lock pawl holds the vehicle in place.
Abnormal Noise and Vibration Check for abnormal noise and vibration while driving the vehicle forward and backward, and during shift operations.
Fluid Leakage After performing all other road test inspections, check for fluid leakage.



HINT:

When checking for DTCs after a repair, drive the vehicle according to the monitor drive pattern.

Click hereDrivetrain>U761E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>MONITOR DRIVE PATTERN


a.

Gear change confirmation

i.

Connect the GTS to the DLC3.


ii.

Turn the engine switch on (IG).


iii.

Enter the following menus: Powertrain / Transmission / Data List.

Powertrain > Transmission > Data List
Tester Display
Vehicle Speed
Coolant Temperature
NT Sensor Speed
A/T Oil Temperature No.1
Shift Status
50003 373 212,205,174,180,179

iv.

Check that the transaxle shifts to each gear while gently accelerating to 80 km/h (50 mph) or higher.

HINT:
·

Check that the value of NT Sensor Speed drops by 50 rpm or more when the value of Shift Status increases.

·

Depending on the engine speed when the gear is changed, it may be difficult to see the change of NT Sensor Speed.





b.

Shift schedule confirmation

i.

Connect the GTS to the DLC3.


ii.

Turn the engine switch on (IG).


iii.

Enter the following menus: Powertrain / Transmission / Data List.

Powertrain > Transmission > Data List
Tester Display
Vehicle Speed
Coolant Temperature
Accel Position from EFI
A/T Oil Temperature No.1
Shift Status
50003 373 212,205,401,180,179

iv.

Check that the "Shift Status" changes in accordance with the "Vehicle Speed" as shown in the following table.

Shift Schedule Chart:
Accel Position from EFI 9 +/- 1%
Shift Status
(Shift Lever in D)
1st to 2nd 2nd to 3rd 3rd to 4th 4th to 5th 5th to 6th
Vehicle Speed 5 to 20 km/h
(3 to 12 mph)
15 to 30 km/h
(9 to 19 mph)
25 to 45 km/h
(16 to 28 mph)
40 to 60 km/h
(25 to 37 mph)
60 to 80 km/h
(37 to 50 mph)


NOTICE:
·

All vehicle speeds indicated in the above table are actual values. Therefore, if checking a shift point with a chassis dynamometer, keep in mind that there is a margin of error in the chassis dynamometer indication.

·

If checking a shift point against the vehicle speed indicated on the speedometer, remember to consider the speedometer correction rate and margin of error in the tester indication.





c.

Lock-up confirmation

i.

Connect the GTS to the DLC3.


ii.

Turn the engine switch on (IG).


iii.

Enter the following menus: Powertrain / Transmission / Data List.

Powertrain > Transmission > Data List
Tester Display
Vehicle Speed
Engine Speed
Coolant Temperature
Accel Position from EFI
NT Sensor Speed
A/T Oil Temperature No.1
Lock Up Status
Shift Status
50003 373 212,211,205,401,174,180,178,179

iv.

When the following conditions are met, check that the difference between "Engine Speed" and "NT Sensor Speed" is 50 rpm or less.

Lock-up Schedule:
Accel Position from EFI 9 +/- 1%
Vehicle Speed 80 km/h (50 mph) or more
Shift Status 6th gear
Lock Up Status ON


HINT:

Lock-up prohibition conditions:

·

Engine coolant temperature is less than 45°C (113°F)

·

Vehicle is being driven with the S1, S2 or S3 range selected

·

Throttle valve is fully closed

·

Stop light switch assembly is on





d.

Manual down-shift permission speed

i.

Manual down-shift is permitted for each shift status when the vehicle speed is below the corresponding range shown in the following table.

Manual Down-shift Permission Speed Chart:
Shift Status
(Shift Lever in S)
6th to 5th 5th to 4th 4th to 3rd 3rd to 2nd 2nd to 1st
Vehicle Speed 245 to 300 km/h
(152 to 186 mph)
175 to 215 km/h
(109 to 134 mph)
125 to 155 km/h
(78 to 96 mph)
90 to 115 km/h
(56 to 71 mph)
40 to 55 km/h
(25 to 34 mph)




e.

Shift schedule when throttle valve is fully open

Shift Schedule Chart:
Throttle Opening Angle Throttle Valve Fully Open
Shift Status
(Shift Lever in D)
1st to 2nd 2nd to 3rd 3rd to 4th 4th to 5th 5th to 6th
Vehicle Speed 50 to 60 km/h
(31 to 37 mph)
95 to 110 km/h
(59 to 68 mph)
130 to 145 km/h
(81 to 90 mph)
190 to 205 km/h
(118 to 127 mph)
255 to 270 km/h
(158 to 168 mph)