Home › Drivetrain › U761E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSAXLE SYSTEM › 2018.04–2021.02
RM33A0E _52 Drivetrain _072210 U761E AUTOMATIC TRANSMISSION / TRANSAXLE _0351183 AUTOMATIC TRANSAXLE SYSTEM D

U761E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MONITOR DRIVE PATTERN  


TEST MONITOR DRIVE PATTERN FOR ECT


CAUTION:

Perform the following procedure on a level surface while strictly observing all traffic laws and speed limits.


HINT:

Performing this drive pattern is one method to simulate the ECM (ECT) malfunction detection conditions.

Some DTCs may not be detected through ordinary, everyday driving. Also, some DTCs may not be detected through this drive pattern.


a.

Preparation for driving

i.

Warm up the engine sufficiently (engine coolant temperature of 60°C (140°F) or higher).


ii.

Drive the vehicle when the ambient temperature is -10°C (14°F) or higher.

Some malfunctions are not detected when the ambient temperature is less than -10°C (14°F).



b.

Drive pattern

C115866E69
2.542,3.885 1.615,2.49 false 3.385,3.438 3.115,3.042 false 2.188,1.74 2.729,0.292 2.729,0.292 2.792,0.292 false 4.875,2.073 5.177,1.26 5.177,1.26 5.24,1.26 false 0.198,0.438 1.146,0.646 0.948,0.208 10 false Vehicle Speed 2.865,0.208 6.042,1.01 3.177,0.802 10 false Maintain a constant speed or gradual acceleration (with the throttle valve open) for 3 minutes or more.* 5.302,1.188 7.094,1.729 1.792,0.542 10 false Lock-up ON Vehicle Speed 3.417,3.417 4.833,3.771 1.417,0.354 10 false Stop (Idling) 2.531,3.917 4.542,4.604 2.01,0.688 10 false Normal acceleration through all gears from 1st to 6th 0.135,3.302 1.667,3.583 1.531,0.281 10 false Warmed up sufficiently 0.969,2.906 1.135,3.125 0.167,0.219 10 false 0 0.167,1.927 1.083,2.5 0.917,0.573 10 false Approximately 80 km/h (50 mph) 0.167,1.083 1.083,1.667 0.917,0.583 10 false Approximately 100 km/h (62 mph)

i.

Drive the vehicle through all of the gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 6th → 6th (lock-up ON).


ii.

Confirm engine braking using the S position. While driving with S6 range selected and 6th gear lock-up on, move the shift lever toward "-" and downshift from 6th to 5th, 5th to 4th, 4th to 3rd, 3rd to 2nd, 2nd to 1st.


iii.

Repeat the above drive pattern three times or more.

NOTICE:
·

When using the GTS, the monitor status can be checked in the Data List.

Click hereDrivetrain>U761E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>DATA LIST / ACTIVE TEST

·

In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.

·

It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P071000 (ATF Temperature Sensor Malfunction).



HINT:

*: Drive at a speed in the highest gear that will cause lock-up to engage. The vehicle can be driven at a speed lower than the speed shown in the above diagram under lock-up.