Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _072211 TELEMATICS _0351443 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B1572  Microphone Error  


DESCRIPTION

This DTC is stored when a microphone signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1572 Microphone Error Current at terminal MCVD exceeds the malfunction threshold for 10 seconds or more while the engine switch is on (IG)
·

Telematics transceiver

·

Roof console box sub-assembly (telephone microphone assembly)

·

Wire harness or connector



WIRING DIAGRAM

E342822E18
0.792,0.594 1.406,0.792 0.615,0.198 10 false MACC 0.823,1.052 1.281,1.26 0.458,0.208 10 false MCO+ 0.844,1.542 1.292,1.74 0.448,0.198 10 false MCO- 1.323,0.49 1.635,0.688 0.313,0.198 10 false 6 1.333,0.948 1.646,1.146 0.313,0.198 10 false 5 1.344,1.427 1.656,1.625 0.313,0.198 10 false 4 5.635,0.479 5.948,0.677 0.313,0.198 10 false 33 5.646,0.958 5.958,1.156 0.313,0.198 10 false 34 5.646,1.427 5.958,1.625 0.313,0.198 10 false 35 5.646,1.917 5.958,2.115 0.313,0.198 10 false 32 5.938,0.583 6.552,0.781 0.615,0.198 10 false MCVD 5.948,1.063 6.563,1.26 0.615,0.198 10 false MCI+ 5.958,1.521 6.573,1.719 0.615,0.198 10 false MCI- 5.958,2.021 6.573,2.219 0.615,0.198 10 false SGND 0.458,2.531 0.771,2.729 0.313,0.198 10 false V20 0.469,2.719 3.198,3.146 2.729,0.427 10 false Roof Console Box Sub-assembly (Telephone Microphone Assembly) 5.875,2.531 6.448,2.75 0.573,0.219 10 false K145 5.885,2.719 6.604,3.073 0.719,0.354 10 false Telematics Transceiver 3.271,1.875 4,2.063 0.729,0.188 10 false (Shielded)

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION


PROCEDURE

1.CHECK DTC
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG) and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

f.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT TELEMATICS TRANSCEIVER
2.INSPECT TELEMATICS TRANSCEIVER
a.
B235166C59
0.917,1.656 1.292,1.281 false 1.313,1.833 1.458,1.281 false 0.104,0.094 0.375,0.354 0.271,0.26 10 false *a 0.938,1.854 1.427,2.021 0.49,0.167 10 false MCVD 0.615,1.646 1.104,1.854 0.49,0.208 10 false MCI-
*a Component with harness connected
(Telematics Transceiver)


Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
33 (MCVD) - Body ground Engine switch on (ACC) 4 to 6 V


Standard Resistance:
Tester Connection Condition Specified Condition
35 (MCI-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))

NG

5.REPLACE TELEMATICS TRANSCEIVER
3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
a.

Disconnect the K145 telematics transceiver connector.


b.

Disconnect the V20 roof console box sub-assembly (telephone microphone assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K145-33 (MCVD) - V20-6 (MACC) Always Below 1 Ω
K145-34 (MCI+) - V20-5 (MCO+) Always Below 1 Ω
K145-35 (MCI-) - V20-4 (MCO-) Always Below 1 Ω
K145-33 (MCVD) or V20-6 (MACC) - Body ground Always 10 kΩ or higher
K145-34 (MCI+) or V20-5 (MCO+) - Body ground Always 10 kΩ or higher
K145-35 (MCI-) or V20-4 (MCO-) - Body ground Always 10 kΩ or higher
K145-32 (SGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEPHONE MICROPHONE ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly with a new or known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE>REMOVAL


b.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE ROOF CONSOLE BOX SUB-ASSEMBLY (TELEPHONE MICROPHONE)

5.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT