Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for ERA-GLONASS) › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _072211 TELEMATICS _0351443 TELEMATICS SYSTEM(for ERA-GLONASS) C

TELEMATICS  TELEMATICS SYSTEM(for ERA-GLONASS)  B15C5  Emergency Switch Error (Open or Short)  


DESCRIPTION

This DTC is stored when the telematics transceiver detects an open or short circuit in the manual (SOS) switch.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C5 Emergency Switch Error (Open or Short) Open or short circuit in the manual (SOS) switch is detected
·

Telematics transceiver

·

Roof console box sub-assembly (manual (SOS) switch)

·

Wire harness or connector



WIRING DIAGRAM

E342833E14
1.229,1.729 1.688,1.927 0.458,0.198 10 false V20 1.229,1.906 3.26,2.313 2.031,0.406 10 false Roof Console Box Sub-assembly (Manual (SOS) Switch) 5.115,1.729 5.729,1.927 0.615,0.198 10 false K145 5.115,1.906 6.625,2.115 1.51,0.208 10 false Telematics Transceiver 3,0.521 3.615,0.719 0.615,0.198 10 false SIG1 5.156,0.646 5.771,0.844 0.615,0.198 10 false SIG1 2.927,1.073 3.542,1.271 0.615,0.198 10 false GND3 5.156,1.083 5.771,1.281 0.615,0.198 10 false SIG- 3.406,0.521 3.583,0.719 0.177,0.198 10 false 17 3.406,1.073 3.625,1.302 0.219,0.229 10 false 12 4.927,0.521 5.24,0.719 0.313,0.198 10 false 27 4.917,1.083 5.229,1.281 0.313,0.198 10 false 26

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>REGISTRATION


PROCEDURE

1.CHECK DTC
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG) and wait for 10 seconds or more.


d.

Turn the GTS on.


e.

Clear the DTCs.

Body Electrical > Telematics > Clear DTCs
50002 233

f.

Check for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)
2.INSPECT ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)
a.

Remove the roof console box sub-assembly (manual (SOS) switch).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.
B129570C40
2.667,1.844 2.417,1.333 false 1.719,1.865 1.438,1.333 false 0.115,0.094 0.385,0.313 0.271,0.219 10 false *a 2.719,1.781 3.229,2.063 0.51,0.281 10 false GND3 1.781,1.802 2.198,2.01 0.417,0.208 10 false SIG1
*a Component without harness connected
(Roof Console Box Sub-assembly (Manual (SOS) Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
17 (SIG1) - 12 (GND3) Manual (SOS) switch not pressed 392 to 432 Ω
17 (SIG1) - 12 (GND3) Manual (SOS) switch pressed 78 to 86 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))

NG

REPLACE ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH)

3.CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER - ROOF CONSOLE BOX SUB-ASSEMBLY (MANUAL (SOS) SWITCH))
a.

Disconnect the K145 telematics transceiver connector.


b.

Disconnect the V20 roof console box sub-assembly (manual (SOS) switch) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K145-27 (SIG1) - V20-17 (SIG1) Always Below 1 Ω
K145-26 (SIG-) - V20-12 (GND3) Always Below 1 Ω
K145-27 (SIG1) or V20-17 (SIG1) - Body ground Always 10 kΩ or higher
K145-26 (SIG-) or V20-12 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEMATICS TRANSCEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT