The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during side television camera assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.REMOVE OUTER MIRROR
87945
2.REMOVE OUTER MIRROR COVER
3.REMOVE OUTER MIRROR HOLE COVER WITH SIDE TELEVISION CAMERA ASSEMBLY
86790F
4.REMOVE SIDE TELEVISION CAMERA ASSEMBLY
Disengage the 2 guides.
Remove the screw.
Disengage the claw to remove the side television camera assembly from the outer mirror hole cover assembly.