Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PANORAMIC VIEW MONITOR SYSTEM › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _065375 PARK ASSIST / MONITORING _0351447 PANORAMIC VIEW MONITOR SYSTEM C

PARK ASSIST / MONITORING  PANORAMIC VIEW MONITOR SYSTEM  C164D  Wheel Speed Sensor Malfunction  


DESCRIPTION

·

This DTC is stored when the television camera controller receives a wheel speed sensor (front speed sensor RH or front speed sensor LH, rear speed sensor RH or rear speed sensor LH) abnormality signal from the vehicle stability control system via CAN communication.

·

This DTC is stored when the rear television camera assembly receives a wheel speed sensor (front speed sensor RH or front speed sensor LH, rear speed sensor RH or rear speed sensor LH) abnormality signal from the vehicle stability control system via CAN communication.


Television Camera Controller
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C164D Wheel Speed Sensor Malfunction Wheel speed sensor malfunction Vehicle stability control system Circumference Monitoring Camera Control Module

Rear Television Camera Assembly
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C164D Wheel Speed Sensor Malfunction Wheel speed sensor malfunction Vehicle stability control system Rear Camera

PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Chassis > Panoramic View Monitor > Clear DTCs
50002 353
Chassis > Parking Assist Camera > Clear DTCs
50002 85

b.

Check for DTCs.

Chassis > Panoramic View Monitor > Trouble Codes
50001 353
Chassis > Parking Assist Camera > Trouble Codes
50001 85
Result:
Result Proceed to
No DTCs are output A
DTC C164D is output ("Panoramic View Monitor") B
DTC C164D is output ("Parking Assist Camera") C


HINT:

If the television camera controller cannot read the stored information when activated, allowing the ECU to store the information again may return the system to normal.


HINT:
·

The DTC is stored when a malfunction occurs in the vehicle stability control system.

·

If troubleshooting and repair of the malfunction in the vehicle stability control system have been completed, DTC C164D will not be output again when rechecking for DTCs.

·

If DTC C164D is stored frequently, duplicate the problem symptoms and perform troubleshooting again even if the DTC is not output when rechecking for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE





A

B

C