This DTC is stored when the television camera controller judges that the camera initial setting has not been memorized (camera view adjustment is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C1697 | Camera Position Adjustment Incomplete | Camera initial setting has not been memorized | ·
Camera view adjustment ·
Television camera controller |
Circumference Monitoring Camera Control Module |
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Perform the following procedure depending on the memory conditions to register the vehicle information to the television camera controller.
Refer to camera view adjustment.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
DTC C1697 is not output.
If DTC C1697 is output, perform the camera view adjustment again.
If DTC C1697 is still output after performing the camera view adjustment 3 times, replace the television camera controller.
| Proceed to |
|---|
| OK |
| NG |
OK
NG