Home › Audio / Visual / Telematics › AUDIO / VIDEO › AMPLIFIER ANTENNA › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _065373 AUDIO / VIDEO _0318993 AMPLIFIER ANTENNA A

AUDIO / VIDEO  AMPLIFIER ANTENNA  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during amplifier antenna assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION (w/ Rear Seat Side Airbag)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag)

for 2AR-FE:

Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>REMOVAL

for A25A-FKS:

Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL

for 2GR-FKS:

Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL

for 6AR-FSE:

Click hereGeneral>MAINTENANCE>6AR-FSE BATTERY>REMOVAL

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If an airbag deploys for any reason, it may cause a serious injury.



Hide 3.REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)

Hide 62332A 4.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fixed Seat Type)

Hide 62331A 5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fixed Seat Type)

HINT:

Use the same procedure as for the LH side.


Hide 73350C 6.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type)

Hide 7.REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

Hide 72693 8.REMOVE REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)

Hide 62332A 9.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Fold Down Seat Type)

Hide 10.REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)

Hide 62331A 11.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type)

HINT:

Use the same procedure as for the LH side.


Hide 12.REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)

HINT:

Use the same procedure as for the LH side.


Hide 71940A 13.REMOVE REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type)

Hide 73350C 14.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Reclining Seat Type)

Hide 15.REMOVE REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)

Hide 72693 16.REMOVE REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type)

Hide 72996A 17.REMOVE REAR SEATBACK COVER (for Reclining Seat Type)

Hide 18.REMOVE REAR SEATBACK ASSEMBLY LH (for Reclining Seat Type)

Hide 62332A 19.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH (for Reclining Seat Type)

Hide 20.REMOVE REAR SIDE SEATBACK ASSEMBLY LH (for Reclining Seat Type)

Hide 21.REMOVE REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type)

Hide 62331A 22.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Reclining Seat Type)

HINT:

Use the same procedure as for the LH side.


Hide 23.REMOVE REAR SIDE SEATBACK ASSEMBLY RH (for Reclining Seat Type)

HINT:

Use the same procedure as for the LH side.


Hide 62472A 24.REMOVE INNER ROOF SIDE GARNISH LH (for Radio and Display Type)

Hide 62471A 25.REMOVE INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 86300C 26.REMOVE NO. 2 AMPLIFIER ANTENNA ASSEMBLY (for Radio and Display Type)

a.
E365051

Disconnect the 2 connectors.


b.

Remove the bolt.


c.

Disengage the 2 guides to remove the No. 2 amplifier antenna assembly.


Hide 86300B 27.REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY

HINT:

Use the same procedure as for the No. 2 amplifier antenna assembly.


Hide 86101S 28.REMOVE ANTENNA CORD SUB-ASSEMBLY (for LH Side)

a.

for Radio and Display Type:

i.
E365052

Disconnect the connector to remove the antenna cord sub-assembly.



Hide 86101S 29.REMOVE ANTENNA CORD SUB-ASSEMBLY (for RH Side)

HINT:

Use the same procedure as for the LH side.