Home › Audio / Visual / Telematics › TELEMATICS › ANTENNA DIVIDER › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _072211 TELEMATICS _0351487 ANTENNA DIVIDER A

TELEMATICS  ANTENNA DIVIDER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna divider removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 55086 2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 86681B 3.REMOVE ANTENNA DIVIDER

a.
E393396

Disconnect the connector.


b.
E393397

Remove the 2 screws and antenna divider.