Home › Engine / Hybrid System › 6AR-FSE (STARTING) › STARTER › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072209 6AR-FSE STARTING _0351490 STARTER A

6AR-FSE STARTING  STARTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE BATTERY

Hide 12601B 3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 53295E 4.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 17750A 5.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 6.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 74404A 8.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28100 9.REMOVE STARTER ASSEMBLY

a.
A420449

Remove the 2 bolts and disconnect the wire harness.


b.
A421294

Disengage the claw, rotate the lever and disconnect the transmission wire connector.


c.
A420450

Remove the terminal cap.


d.

Remove the nut and disconnect terminal 30.


e.

Disconnect the starter assembly connector.


f.
A420451

Remove the 2 bolts and starter assembly.