Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE (for Intake Side) › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351509 CAMSHAFT OIL CONTROL VALVE(for Intake Side) A

6AR-FSE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Intake Side)  REMOVAL  


PROCEDURE

Hide 53736 1.REMOVE FRONT FENDER APRON SEAL RH

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 15370 3.REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

Hide 4.SET NO. 1 CYLINDER TO TDC/COMPRESSION

a.
A338578C01
1.719,0.427 1.979,0.427 true 1.677,0.552 1.906,1.125 1.906,1.125 2.292,1.125 true 2.021,0.344 2.208,0.531 0.188,0.188 10 true *a 2.323,1.031 2.521,1.219 0.198,0.188 10 true *b
*a Timing Mark "0"
*b Timing Notch (Groove)


Turn the crankshaft pulley until its timing notch (groove) is aligned with the timing mark "0" of the timing chain cover sub-assembly.


b.
A338579C01
0.854,0.281 1.219,0.281 1.219,0.281 1.49,0.74 true 0.667,0.188 0.865,0.427 0.198,0.24 10 true *a 0.208,1.396 0.521,1.552 0.313,0.156 10 false *b
*a Protrusion
*b Top


Check that the protrusion of the camshaft timing gear assembly is at the top.

HINT:

If the protrusion is not at the top, rotate the crankshaft pulley 360° clockwise and align the timing notch (groove) with the timing mark "0" again.



Hide 13523F 5.REMOVE CAMSHAFT TIMING GEAR BOLT

a.
A413305

Disengage the clamp to disconnect the engine wire.


b.
A337986

While holding the crankshaft pulley set bolt, remove the camshaft timing gear bolt from the camshaft timing gear assembly.

NOTICE:

If the camshaft timing gear bolt has been struck or dropped, replace it.