Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351519 ENGINE COOLANT TEMPERATURE SENSOR A

6AR-FSE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17705 2.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 3.DRAIN ENGINE COOLANT

Hide 89422 4.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A413349

Disconnect the engine coolant temperature sensor connector.


b.
A413350N01
1.74,0.958 2.063,0.625 2.063,0.625 2.313,0.625 true 2.333,0.542 2.792,0.74 0.458,0.198 10 true SST

Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.

SST
09817-33191  

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.



c.

Remove the gasket from the engine coolant temperature sensor.