Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE › from 2018.04
RM33A0E _59 Vehicle Exterior _065394 WIPER / WASHER _0320462 WASHER NOZZLE A

WIPER / WASHER  WASHER NOZZLE  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 53341B 1.REMOVE HOOD INSULATOR (w/ Heater)

Hide 85035 2.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)

a.
E364826C01
1.948,2.844 2.25,2.302 true 1.844,2.844 2.021,3.01 0.177,0.167 10 true *a
*a Protective Tape
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Using a screwdriver, disengage the 2 claws as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.

NOTICE:

Be careful not to damage the windshield glass.


HINT:

Tape the screwdriver tip before use.



b.
E364827

Disconnect the washer hose to remove the washer nozzle sub-assembly.

NOTICE:

Washer nozzle sub-assemblies cannot be reused.



Hide 3.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ Heater)

a.
E390712

Disconnect the connector.


b.

Disconnect the washer hose.


c.

Disengage the clamp.


d.
E390714

Tie a string to the washer hose and wire harness of the washer nozzle sub-assembly.


e.
E390715C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Using a moulding remover, disengage the 2 claws as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.

NOTICE:

Be careful not to damage the windshield glass.



f.

Pull the washer nozzle sub-assembly from the hood sub-assembly to remove it.

NOTICE:
·

Washer nozzle sub-assemblies cannot be reused.

·

Leave the string inside the hood sub-assembly.




g.

Remove the string from the washer hose and wire harness of the washer nozzle sub-assembly.