Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
85035
1.INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)
Connect a new washer nozzle sub-assembly to the washer hose.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the 2 claws as indicated by the arrows, in the order shown in the illustration to install the washer nozzle sub-assembly.
2.INSTALL WASHER NOZZLE SUB-ASSEMBLY (w/ Heater)
Tie the string that was passed through the hood sub-assembly to the washer hose and wire harness of a new washer nozzle sub-assembly.
Pass the washer hose and wire harness of the washer nozzle sub-assembly through the hood sub-assembly.
Remove the string from the washer hose and wire harness of the washer nozzle sub-assembly.
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the 2 claws as indicated by the arrows, in the order shown in the illustration to install the washer nozzle sub-assembly.
Engage the clamp.
Connect the washer hose.
Connect the connector.
85035
3.INSPECT WASHER NOZZLE SUB-ASSEMBLY
85035
4.ADJUST WASHER NOZZLE SUB-ASSEMBLY
53341B
5.INSTALL HOOD INSULATOR (w/ Heater)