Home › Steering › STEERING COLUMN › STEERING WHEEL › 2018.04–2021.02
RM33A0E _55 Steering _065371 STEERING COLUMN _0319592 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering wheel assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

NOTICE:
·

Do not remove/install the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 1.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 45130 2.REMOVE HORN BUTTON ASSEMBLY

Hide 3.REMOVE STEERING WHEEL ASSEMBLY

a.

Disconnect each connector from the spiral cable with sensor sub-assembly.


b.

w/ Steering Heater:

i.
C395281

Disconnect the steering heater connector.



c.
C384418

Using a 10 mm hexagon socket wrench, remove the steering wheel assembly set bolt.


d.
C384419C01
0.25,1.031 1.688,1.031 true 0.979,1.031 0.979,1.073 0.979,1.073 1.688,1.073 true 0.094,0.948 0.406,1.104 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the steering wheel assembly and steering main shaft.


e.

Temporarily install the steering wheel assembly set bolt.

NOTICE:

Do not overtighten the steering wheel assembly set bolt.



f.
C384420C01
0.417,0.896 1.583,0.896 true 0.406,1.26 1.073,1.26 true 3.146,3.604 3.427,3.833 0.281,0.229 10 false *a 0.958,4.042 1.271,4.198 0.313,0.156 10 false *b 0.115,0.813 0.573,1.01 0.458,0.198 10 false SST 0.115,1.177 0.573,1.375 0.458,0.198 10 false SST
*a Turn
*b Hold


Using SST, separate the steering wheel assembly.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05031, 09957-04010)
09950-60010  (09951-00330)

NOTICE:

Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



g.

Remove the steering wheel assembly set bolt and steering wheel assembly.


Hide 84250A 4.REMOVE STEERING PAD SWITCH ASSEMBLY

Hide 84610F 5.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)