The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly RH removal/installation are shown below.
1.REMOVE FRONT WHEEL
53736
2.REMOVE FRONT FENDER APRON SEAL RH
for 2AR-FE: Click hereEngine / Hybrid System>2AR-FE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
for 6AR-FSE: Click hereEngine / Hybrid System>6AR-FSE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL
48068
3.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH
Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly RH from the front lower ball joint assembly RH.
Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly RH from the front frame assembly.
Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.
Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly RH.