Home › Engine / Hybrid System › 6AR-FSE (FUEL) › FUEL PUMP (for High Pressure) › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072204 6AR-FSE FUEL _0353739 FUEL PUMP(for High Pressure) G

6AR-FSE FUEL  FUEL PUMP(for High Pressure)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. FUEL PUMP WITH SEAL SUB-ASSEMBLY OPERATION

a.

Check fuel pressure.

i.

Connect the GTS to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset / Fuel Pressure (High).

Powertrain > Engine > Active Test
Active Test Display
Control the Target Fuel Pressure Offset
Data List Display
Fuel Pressure (High)
50004 372 6 265

v.

Check that the fuel pressure fluctuates when the target fuel pressure changes.

HINT:

The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.


If the result is not as specified, replace the fuel pump with seal sub-assembly or fuel pressure sensor.



b.

Check operating sound.

i.

Remove the No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>6AR-FSE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>REMOVAL


ii.

Start the engine.


iii.

Using a sound scope, check the operating sound of the fuel pump with seal sub-assembly.

If no sound can be heard, check the fuel pump with seal sub-assembly, wire harness and ECM.


iv.

Stop the engine.


v.

Install the No. 1 engine cover sub-assembly.

Click hereEngine / Hybrid System>6AR-FSE (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION