The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
63218M
1.REMOVE NO. 3 SLIDING ROOF SIDE GARNISH LH
Move the sunshade trim sub-assembly to the fully opened position.
Remove the No. 3 sliding roof side garnish LH.
63217K
2.REMOVE NO. 3 SLIDING ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
63218M
3.REMOVE NO. 4 SLIDING ROOF SIDE GARNISH LH
Remove the No. 4 sliding roof side garnish LH.
63217K
4.REMOVE NO. 4 SLIDING ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
63218M
5.REMOVE NO. 2 SLIDING ROOF SIDE GARNISH LH
Move the sliding roof glass sub-assembly to the fully tilted up position.
Remove the No. 2 sliding roof side garnish LH.
63217K
6.REMOVE NO. 2 SLIDING ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
63201G
7.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY
Move the sliding roof glass sub-assembly to the fully closed position.
Using a T25 "TORX" socket wrench, remove the 6 screws and sliding roof glass sub-assembly.
To prevent the sliding roof glass sub-assembly and sliding roof drive gear assembly from becoming misaligned, move the sliding roof glass sub-assembly to the fully closed position before removing.
62180A
8.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
62170A
9.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedure as for the LH side.
63249E
10.DISCONNECT SLIDING ROOF DRAIN HOSE
Use the same procedure for all of the sliding roof drain hoses.
for Clamp Type:
Disengage the claw and disconnect the sliding roof drain hose.
for Clip Type:
Expand the clip and disconnect the sliding roof drain hose.
63242A
11.REMOVE FRONT SLIDING ROOF HOUSING MOUNTING BRACKET LH
|
Bolt |
|
Nut |
Remove the bolt, nut and front sliding roof housing mounting bracket LH.
63241A
12.REMOVE FRONT SLIDING ROOF HOUSING MOUNTING BRACKET RH
Use the same procedure as for the LH side.
63244C
13.REMOVE CENTER SLIDING ROOF HOUSING MOUNTING BRACKET LH
|
Bolt |
|
Nut |
Remove the 2 bolts, 2 nuts and center sliding roof housing mounting bracket LH.
63243C
14.REMOVE CENTER SLIDING ROOF HOUSING MOUNTING BRACKET RH
Use the same procedure as for the LH side.
63246D
15.REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET LH
|
Bolt |
|
Nut |
Remove the 2 bolts, 2 nuts and 2 rear sliding roof housing mounting brackets LH.
63245D
16.REMOVE REAR SLIDING ROOF HOUSING MOUNTING BRACKET RH
Use the same procedure as for the LH side.
17.REMOVE SLIDING ROOF HOUSING ASSEMBLY
Remove the 20 nuts.
Disengage the 2 guides and remove the sliding roof housing assembly.