Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › KNOCK SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065332 2GR-FKS ENGINE CONTROL _0326388 KNOCK SENSOR A

2GR-FKS ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
·

Replacement of knock control sensor

·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 89615 2.REMOVE KNOCK CONTROL SENSOR

a.
A371936C01
1.938,0.948 2.281,0.583 2.281,0.583 2.469,0.583 true 1.698,1.927 1.948,1.927 1.948,1.927 2.188,1.427 true 2.469,0.51 2.688,0.677 0.219,0.167 10 true *A 1.49,1.854 1.708,2.021 0.219,0.167 10 true *B
*A for Bank 1
*B for Bank 2


Disconnect the 2 knock control sensor connectors.


b.

Remove the 2 bolts and 2 knock control sensors from the cylinder block sub-assembly.

NOTICE:

If a knock control sensor has been struck or dropped, replace it.