The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.REMOVE BATTERY
12601B
3.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
53295E
4.REMOVE COOL AIR INTAKE DUCT SEAL
17750A
5.REMOVE INLET AIR CLEANER ASSEMBLY
6.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
89661
7.REMOVE ECM
74404A
8.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28100
9.REMOVE STARTER ASSEMBLY
Remove the 2 bolts and disconnect the wire harness.
Remove the terminal cap.
Remove the nut and disconnect terminal 30.
Disconnect the starter assembly connector.
Remove the 2 bolts and starter assembly.