Home › Engine / Hybrid System › 2GR-FKS (STARTING) › STARTER › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065339 2GR-FKS STARTING _0328805 STARTER A

2GR-FKS STARTING  STARTER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE BATTERY

Hide 53295E 3.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 11209 4.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 17750A 5.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 17700 6.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 74404A 8.REMOVE BATTERY CLAMP SUB-ASSEMBLY

Hide 28100 9.REMOVE STARTER ASSEMBLY

a.
A407330

Disconnect the starter assembly connector.


b.

Open the terminal cap.


c.

Remove the nut and disconnect the engine wire from the terminal 30.


d.
A407331

Remove the 2 bolts and starter assembly.