The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during black out tape removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 2AR-FE:
Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>REMOVAL
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL
for 2GR-FKS:
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
74038A
4.REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY
5.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
6.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
74220
7.REMOVE FRONT ARMREST ASSEMBLY
81230
8.REMOVE COURTESY LIGHT ASSEMBLY
67602
9.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
10.REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL
67832
11.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
67856B
13.REMOVE FRONT DOOR PANEL PROTECTOR
68151C
14.REMOVE FRONT DOOR GLASS RUN
67862
15.DISCONNECT FRONT DOOR WEATHERSTRIP
67664C
16.REMOVE DOOR FRAME GARNISH
75976G
17.REMOVE FRONT DOOR NO. 2 STRIPE
When removing the front door No. 2 stripe, heat the vehicle body and front door No. 2 stripe using a heat light.
| Item | Temperature |
|---|---|
| Front Door No. 2 Stripe and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Using a heat light, heat the front door No. 2 stripe and vehicle body.
Pull back on one of the ends of the front door No. 2 stripe to remove it.
When pulling on the front door No. 2 stripe, pull it parallel to the vehicle body.
75986B
18.REMOVE FRONT DOOR NO. 3 STRIPE
When removing the front door No. 3 stripe, heat the vehicle body and front door No. 3 stripe using a heat light.
| Item | Temperature |
|---|---|
| Front Door No. 3 Stripe and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Using a heat light, heat the front door No. 3 stripe and vehicle body.
Pull back on one of the ends of the front door No. 3 stripe to remove it.
When pulling on the front door No. 3 stripe, pull it parallel to the vehicle body.