Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › ANTENNA CORD › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328085 ANTENNA CORD A

NAVIGATION / MULTI INFO DISPLAY  ANTENNA CORD  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 55086 2.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 86101H 3.REMOVE ANTENNA CORD SUB-ASSEMBLY

a.
E371951

Disconnect the connector.


b.

Disengage the 2 claws.


c.

Disengage the clamp to remove the antenna cord sub-assembly.


Hide 4.REMOVE ROOF HEADLINING ASSEMBLY (w/ Television Antenna)

Hide 86101D 5.REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (w/ Television Antenna)

a.
E375821

Disconnect the connector.


b.

Disengage the clamp to remove the No. 3 antenna cord sub-assembly.