The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ion generator sub-assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
55971C
2.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
55972C
3.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT (w/ Headup Display)
55950G
4.REMOVE DEFROSTER NOZZLE ASSEMBLY (w/ Headup Display)
83108
5.REMOVE METER MIRROR SUB-ASSEMBLY (w/ Headup Display)
55084E
6.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
87201N
7.REMOVE AIR DUCT SUB-ASSEMBLY (for RHD)
|
Remove in this Direction |
Remove the screw and air duct sub-assembly as shown in the illustration.
8.REMOVE ION GENERATOR WITH BRACKET
for LHD:
Disconnect the connector.
Remove the 2 screws.
Disengage the 2 guides to remove the ion generator with bracket.
for RHD:
Disconnect the connector.
Remove the 2 screws.
Disengage the 2 guides to remove the ion generator with bracket.
87201N
9.REMOVE AIR DUCT SUB-ASSEMBLY (for LHD)
|
Remove in this Direction |
Remove the screw and air duct sub-assembly as shown in the illustration.
88051A
10.REMOVE ION GENERATOR SUB-ASSEMBLY
Remove the 3 screws and ion generator sub-assembly from the No. 1 ion generator bracket.