Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0327012 HAZARD WARNING SWITCH A

LIGHTING (EXT)  HAZARD WARNING SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during hazard warning signal switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 55971C 2.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

Hide 55972C 3.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 83108 5.REMOVE METER MIRROR SUB-ASSEMBLY (w/ Headup Display)

Hide 55084E 6.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55086 7.REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55085 8.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 55660 9.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 84330 10.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E365638C01
0.75,0.646 1.365,0.646 true 0.583,0.542 0.896,0.698 0.313,0.156 10 false *a
*a Protective Tape
V113147

Remove in this Direction


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the hazard warning signal switch assembly as shown in the illustration.