Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065395 LIGHTING (EXT) _0327015 AUTOMATIC LIGHT CONTROL SENSOR A

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during automatic light control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1.REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Hide 55971C 2.REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT

Hide 55972C 3.REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT

Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 89120A 5.REMOVE AUTOMATIC LIGHT CONTROL SENSOR

a.
E365647

Disconnect the connector.


b.

Disengage the 2 claws to remove the automatic light control sensor.