Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
85720D
2.INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.
3.INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
68102
4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
5.INSTALL FRONT DOOR SERVICE HOLE COVER
6.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL
67602
7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
81230
8.INSTALL COURTESY LIGHT ASSEMBLY
74220
9.INSTALL FRONT ARMREST ASSEMBLY
10.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
11.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
74038A
12.INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY
67492A
13.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
14.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 2AR-FE:
Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>INSTALLATION
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION
for 6AR-FSE:
15.INITIALIZE POWER WINDOW CONTROL SYSTEM
16.INSPECT POWER WINDOW OPERATION