The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear upper control arm assembly removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced
| Replaced Part or Performed Procedure
|
Necessary Procedure
|
Effect/Inoperative Function when Necessary Procedure not Performed
|
Link
|
| Rear wheel alignment adjustment
|
Perform system variant learning and acceleration sensor zero point calibration.
|
·
VSC disabled or malfunctioning
·
Slip indicator light illuminated
·
ABS warning light illuminated
|
( )
|
Suspension, tires
(The vehicle height changes because of suspension or tire replacement.)
|
Rear television camera assembly optical axis (Back camera position setting)
|
Parking assist monitor system
|
( )for Initialization
( )for Calibration
|
·
Television camera controller initialization
·
Rear television camera assembly optical axis (Back camera position setting)
|
Panoramic view monitor system
|
( )for Initialization
( )for Calibration
|
| Perform headlight ECU sub-assembly LH initialization
|
Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System)
|
( )
|
| Rear height control sensor sub-assembly LH
|
Perform headlight ECU sub-assembly LH initialization
|
Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System)
|
( )
|
| Gas leak from exhaust system is repaired
|
Inspection After Repair
|
·
Engine start function, etc.
|
( )for 2AR-FE
( )for A25A-FKS (w/ Canister Pump Module)
( )for A25A-FKS (w/o Canister Pump Module)
( )for 2GR-FKS
( )for 6AR-FSE
|
- CAUTION:
-
-
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.