Home › Engine / Hybrid System › 2AR-FE (COOLING) › WATER PUMP › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065328 2AR-FE COOLING _0319474 WATER PUMP A

2AR-FE COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine water pump assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 27020 2.REMOVE GENERATOR ASSEMBLY

Hide 16620 3.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 16100 4.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A194904

Remove the 7 bolts, engine water pump assembly and water pump gasket.