Home › Engine / Hybrid System › A25A-FKS (COOLING) › THERMOSTAT › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065346 A25A-FKS COOLING _0319572 THERMOSTAT A

A25A-FKS COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during water inlet with thermostat sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 16572D 3.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16031 4.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.
A402015

Disconnect the water inlet with thermostat sub-assembly connector.


b.
A402016

Slide the clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

NOTICE:
·

Do not apply force to the water inlet with thermostat sub-assembly when disconnecting the No. 7 water by-pass hose.

·

Do not damage the water inlet with thermostat sub-assembly.



HINT:

When disconnecting the No. 7 water by-pass hose, slide the clip, rotate the hose and pull it straight off the pipe.



c.
A402017

Using an 8 mm socket wrench, remove the 2 bolts and water inlet with thermostat sub-assembly.


d.
A402018

Remove the gasket from the water inlet with thermostat sub-assembly.