The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
2.DRAIN FUEL
17420
3.REMOVE CENTER EXHAUST PIPE ASSEMBLY
58399D
4.REMOVE NO. 2 FLOOR UNDER COVER
58398F
5.REMOVE NO. 1 FLOOR UNDER COVER
77641A
6.REMOVE NO. 1 FUEL TANK PROTECTOR
| *a | Needle Nose Pliers |
Using needle nose pliers, remove the 4 clips and No. 1 fuel tank protector from the fuel tank assembly.
77209F
7.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disconnect the fuel tank main tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
8.DISCONNECT FUEL TANK BREATHER TUBE SUB-ASSEMBLY
Disconnect the fuel tank breather tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
77213E
9.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
77100
10.REMOVE FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
w/ Fuel Outlet Valve Assembly:
Disconnect the fuel cut off valve with tube assembly from the fuel outlet valve assembly.
Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
w/o Fuel Outlet Valve Assembly:
Disconnect the fuel cut off valve with tube assembly from the canister (charcoal canister assembly).
Click hereEngine / Hybrid System>A25A-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
Support the fuel tank assembly using an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Remove the 4 bolts, No. 1 fuel tank band sub-assembly LH and No. 1 fuel tank band sub-assembly RH.
Lower the engine lifter to remove the fuel tank assembly.
Be careful not to drop the fuel tank assembly.
When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77209F
11.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY
Disengage the clamp to remove the fuel tank main tube sub-assembly from the fuel tank assembly.
77656B
12.REMOVE NO. 6 FUEL TANK CUSHION
Remove the No. 6 fuel tank cushion from the fuel tank assembly.
77652A
13.REMOVE NO. 2 FUEL TANK CUSHION
Remove the 2 No. 2 fuel tank cushions from the fuel tank assembly.