Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
69760C
2.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
|
Install in this Direction |
Install the front door inside locking cable assembly as shown in the illustration.
69720B
3.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
|
Install in this Direction |
Install the front door lock remote control cable assembly as shown in the illustration.
69036A
4.INSTALL FRONT DOOR LOCK COVER SUB-ASSEMBLY
|
Install in this Direction |
Engage the 2 claws as shown in the illustration.
Engage the 2 claws to install the front door lock cover sub-assembly as shown in the illustration.
69040A
5.INSTALL FRONT DOOR LOCK WITH MOTOR ASSEMBLY
When reusing a removed front door lock with motor assembly, replace the door lock wiring harness seal with a new one.
Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.
Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door lock with motor assembly.
Apply MP grease to the sliding parts of the front door lock with motor assembly.
When reusing the front door lock with motor assembly:
Install a new door lock wiring harness seal to the front door lock with motor assembly.
| *1 | Front Door Lock Open Rod |
|
Install in this Direction |
Connect the front door lock open rod to the front door lock with motor assembly.
Make sure that the front door lock open rod is securely connected to the front door lock with motor assembly.
Using a T30 "TORX" socket wrench, install the front door lock with motor assembly with the 3 screws.
Connect the connector.
6.INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)
69220
7.INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)
67404F
8.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
68151C
9.INSTALL FRONT DOOR GLASS RUN
67856B
10.INSTALL FRONT DOOR PANEL PROTECTOR
68102
11.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
12.INSTALL FRONT DOOR SERVICE HOLE COVER
13.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP WITH FRONT DOOR VENT SEAL
67602
14.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
81230
15.INSTALL COURTESY LIGHT ASSEMBLY
74220
16.INSTALL FRONT ARMREST ASSEMBLY
17.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
18.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
74038A
19.INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY
67492A
20.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
21.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 2AR-FE:
Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>INSTALLATION
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION
for 6AR-FSE:
22.INITIALIZE POWER WINDOW CONTROL SYSTEM
23.INSPECT POWER WINDOW OPERATION