Home › Engine / Hybrid System › 2AR-FE (INTAKE / EXHAUST) › INTAKE AIR CONTROL VALVE ACTUATOR (for TCV) › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065327 2AR-FE INTAKE / EXHAUST _0328638 INTAKE AIR CONTROL VALVE ACTUATOR(for TCV) A

2AR-FE INTAKE / EXHAUST  INTAKE AIR CONTROL VALVE ACTUATOR(for TCV)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake air control valve actuator (for TCV) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
·

Replacement of throttle body assembly

·

Cleaning the deposits from the throttle body assembly

·

Replacement of fuel injector assembly


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 17335 2.REMOVE INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)

a.
A196059

Remove the 2 bolts and intake air control valve actuator (for TCV) from the intake manifold.

NOTICE:
·
A203084

Make sure that foreign matter, such as water, oil, sand or iron particles, does not enter the gear chamber or intake air control valve actuator (for TCV) at the locations marked by the circles in the illustration.

·
A197294

Do not loosen or remove the bolt or 2 nuts shown in the illustration.




b.

Remove the gasket from the intake air control valve actuator (for TCV).