Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › SHIFT LEVER › from 2019.10
RM33A0E _52 Drivetrain _065351 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0319830 SHIFT LEVER A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  SHIFT LEVER  REMOVAL  


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33554C 2.REMOVE SHIFT LOCK RELEASE BUTTON COVER

a.
C370818C01
1.083,1.021 1.667,1.021 true 0.844,0.906 1.063,1.104 0.219,0.198 10 true *a
*a Protective Tape


Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and guide to remove the shift lock release button cover from the rear upper console panel sub-assembly.

NOTICE:

Be careful not to damage the shift lock release button cover and rear upper console panel sub-assembly.



Hide 33504F 3.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 33820B 5.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

Before disconnecting the transmission control cable assembly, check that the shift lever is in N.


a.
C413140

Disconnect the transmission control cable assembly from the transmission floor shift assembly.


b.
C413141C01
1.052,2.469 1.229,2.667 0.177,0.198 10 true *a
*a Counterclockwise


Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.


Hide 6.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

C374428

a.

Remove the 4 bolts.


b.
C370821

Remove the clip from the No. 1 console box duct.


c.
C374429

Disconnect the transmission control switch connector.


d.

Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.


e.
C374430

Disconnect the shift lock control ECU connector.


f.

Disengage the clamp to disconnect the wire harness from the transmission floor shift assembly.


g.

Remove the transmission floor shift assembly.