The headlight ECU sub-assembly LH determines the vehicle height and performs automatic headlight beam level control based on signals from the rear height control sensor sub-assembly LH via direct line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B241A | Rear Height Control Sensor | Detection condition:
The ignition switch is ON. Malfunction status:
Abnormal vehicle height continuously detected Malfunction duration:
10 seconds or more |
·
Rear height control sensor sub-assembly LH ·
Harness or connector ·
Headlight ECU sub-assembly LH |
HL AutoLeveling |
If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
If any of the following are performed, it is necessary to initialize the headlight ECU sub-assembly LH.
Replacement of the rear height control sensor sub-assembly LH
Removal/installation of the rear height control sensor sub-assembly LH
Work that changes the vehicle height such as replacement of suspension components
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Wait 10 seconds or more.
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
DTC B241A is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Remove the rear height control sensor sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>REMOVAL
Inspect the rear height control sensor sub-assembly LH.
Click hereVehicle Exterior>LIGHTING (EXT)>HEIGHT CONTROL SENSOR>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A83 headlight ECU sub-assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U1-3 (SHB) - A83-16 (SBR) | Always | Below 1 Ω |
| U1-2 (SHRR) - A83-17 (SHRL) | Always | Below 1 Ω |
| U1-1 (SHG) - A83-15 (SGR) | Always | Below 1 Ω |
| U1-3 (SHB) or A83-16 (SBR) - Body ground | Always | 10 kΩ or higher |
| U1-2 (SHRR) or A83-17 (SHRL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG