Home › Drivetrain › K120 (CVT) › REVOLUTION SENSOR (NT SENSOR) › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461781 REVOLUTION SENSOR(NT SENSOR) A

K120 CVT  REVOLUTION SENSOR(NT SENSOR)  INSTALLATION  


PROCEDURE

Hide 89413N 1.INSTALL TRANSMISSION REVOLUTION SENSOR (NT)

a.

Coat a new O-ring with Toyota Genuine CVT fluid FE and install it to the transmission revolution sensor (NT).

NOTICE:

Ensure that the O-ring is not twisted.



b.

Install the transmission revolution sensor (NT) to the rear transaxle case sub-assembly with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

Be careful not to damage the O-ring.



c.

Connect the transmission revolution sensor (NT) connector.


Hide 2.INSPECT FOR FLUID LEAKS

Hide 53737B 3.INSTALL FRONT FENDER APRON SEAL LH