Home › Drivetrain › K120 (CVT) › REVOLUTION SENSOR (NSS SENSOR) › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461784 REVOLUTION SENSOR(NSS SENSOR) A

K120 CVT  REVOLUTION SENSOR(NSS SENSOR)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor (NSS) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Not necessary when TCM replaced with new one

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
TCM
(If transaxle compensation code read from TCM)
·

Transfer transaxle compensation code

·

Perform reset memory*1

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)
for Initialization
(Click here)
for Registration
TCM
(If transaxle compensation code not read from TCM)
·

Reset transaxle compensation code

·

Perform reset memory*1

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn



NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 89535B 1.REMOVE TCM

Hide 89413T 2.REMOVE TRANSMISSION REVOLUTION SENSOR (NSS)

a.
C413810

Disconnect the transmission revolution sensor (NSS) connector.


b.
C413811

Remove the bolt and transmission revolution sensor (NSS) from the transaxle case sub-assembly.


c.
C395501

Remove the O-ring from the transmission revolution sensor (NSS).