Home › Drivetrain › K120 (CVT) › TRANSMISSION WIRE › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461793 TRANSMISSION WIRE A

K120 CVT  TRANSMISSION WIRE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission wire removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Transmission valve body assembly
·

Reset transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)
for Initialization
(Click here)
for Registration
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 35410J 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 82125M 2.REMOVE TRANSMISSION WIRE

a.
C413841C01
0,0 0,0 false
V113147

Rotate in this Direction


Disengage the claw, rotate the lever and disconnect the transmission wire connector.


b.
C399131

Disconnect the transmission revolution sensor (NC1) connector.


c.
C413840

Remove the bolt and transmission wire from the transaxle case sub-assembly.


d.
C395524

Remove the O-ring from the temperature sensor.