Home › Drivetrain › K120 (CVT) › VALVE BODY ASSEMBLY › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461794 VALVE BODY ASSEMBLY A

K120 CVT  VALVE BODY ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Replacement of transmission valve body assembly
·

Reset transaxle compensation code

·

Perform reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)
for Initialization
(Click here)
for Registration
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 35015Y 1.REMOVE TRANSAXLE SIDE COVER SUB-ASSEMBLY

Hide 35410J 2.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

a.
C413844

Disengage the clamp to disconnect the transmission wire from the solenoid lock plate.


b.

Disconnect the 6 solenoid valve connectors.


c.
C399125

Remove the bolt and temperature sensor clamp from the transmission valve body assembly.


d.

Disconnect the temperature sensor from the transmission valve body assembly.


e.
C395524

Remove the O-ring from the temperature sensor.


f.
C413845

Remove the 11 bolts and transmission valve body assembly from the transaxle case sub-assembly.

NOTICE:

Make sure the manual valve does not fall out when removing the transmission valve body assembly, as the manual valve is not secured to the transmission valve body assembly.



g.
C399129

Remove the front oil pump cover gasket from the transaxle case sub-assembly.


h.
C399130

Remove the 4 transaxle case gaskets from the transaxle case sub-assembly.