Home › Engine / Hybrid System › M20A-FKS (COOLING) › WATER PUMP › from 2021.02
RM33A0E _51 Engine / Hybrid System _098633 M20A-FKS COOLING _0461854 WATER PUMP A

M20A-FKS COOLING  WATER PUMP  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16032 2.INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.

Using an E8 "TORX" socket wrench, install the stud bolt.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


b.

Install a new gasket to the engine water pump assembly (water inlet housing).

HINT:

Be sure to clean the contact surfaces.



c.

Install a new gasket to the water inlet with thermostat sub-assembly.

HINT:

Be sure to clean the contact surfaces.



d.

Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


e.

Install the engine water pump assembly (water inlet housing) to the cylinder block assembly with the 4 bolts.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


f.

Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


g.

Connect the engine water pump assembly (water inlet housing) connector.


h.

Connect the sensor wire connector.


i.

Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.


j.

Connect the water inlet with thermostat sub-assembly connector.